|
||||
|
#1
|
||||
|
||||
|
Are there any micro motors that could be used as an upgrade to the stock motor used in the losi micro crawler?
__________________
Scale accessorieshttp://crawlcanada.com/forum/showthread.php?t=4806 http://scalercstuff.weebly.com |
|
#2
|
||||
|
||||
|
__________________
TWP, Crawlin' slow since 06' |
|
#3
|
||||
|
||||
|
Just using the 7.4v lipo (if you haven't already) will make a big difference.
![]()
__________________
Scale Innovations "Metal Works and More" Custom Scale R.C. Parts and Accessories. |
|
#4
|
||||
|
||||
|
I have a couple sets of the losi micro crawler axles and radio gear that are going to be scalers and figured I would try to get a bit more speed out of them then a stock motor.I see a few of the micro builds using the plastic frames from the models they are using,but figure they wont hold up too long on a trail ride.
__________________
Scale accessorieshttp://crawlcanada.com/forum/showthread.php?t=4806 http://scalercstuff.weebly.com |
|
#5
|
|||
|
|||
|
dont think them stock worm gears will handle much more.i put the largest pinion in that comes in the box for more speed,with a 7.4 lipo...and those axles get pretty hot.
|
![]() |
| Thread Tools | |
|
|